Nortel Meridian 1 option 11C Planning And Installation Manual page 352

3DJH#685#RI#699 #&KDSWHU#56#±#&KDQJLQJ#SUH0SURJUDPPHG#GDWD
,QWHUIHUHQFH#ZLWK#&DOO#3DUN#H[WHQVLRQ#QXPEHUV
,QWHUIHUHQFH#ZLWK#6',#SRUWV
,QWHUIHUHQFH#ZLWK#WKH#635(#FRGH
886063540543 6WDQGDUG#8133
System call park extension numbers are pre-programmed for the Central
Answering Position. (For some countries, the default call part extensions are
listed in "Important extension numbers" on page 294.) To remove this data
from the system, load LD 50 and respond to the prompts as follows:
/' 83
REQ OUT
TYPE CPK
CUST 0
SPDN XXXX "XXXX" = Value of Call Park extension
Repeat for each Call Park extension you wish to remove.
Five SDI/ESDI ports are pre-programmed on the Option 11 system. Ports 8
and 9 are associated with the Meridian Mail card option, and ports 0, 1 and 2
are associated with the NTDK20 Small System Controller (SSC) card. Port 0
is associated with SSC card and cannot be removed. Any of the remaining
ports can be removed using LD 17 as follows.
/' 4:
REQ CHG
TYPE CFN
ADAN OUT TTY X "X" = the TTY that you are removing.
If the pre-programmed SPRE code interferes with the programming required
for the Option 11 system, use LD 15 to remove it. (For some countries, the
default SPRE access code is listed in "First digits" on page 293.) For
customer 0 enter the following in response to the SPRE prompt:
/' 48
SPRE Xy "y" = the value of the SPRE code
Note: To define a new SPRE code, type a space and enter the new
number.
$SULO#5333