#&KDSWHU#5#²#(TXLSPHQW#LGHQWLILFDWLRQ
)LEHU#([SDQVLRQ#LQWHUIDFHV
The Option 11C Main cabinet can be connected to;
•
up to two expansion cabinets using single port Fiber Expansion
Daughterboards.
•
up to four expansion cabinets using dual port Fiber Expansion
Daughterboards.
The Fiber Expansion Daughterboards are mounted on the on the NTDK20
SSC card (see Figure 5 on page 25). Each port on the Fiber Expansion
Daughterboard also provides an additional 16 channels of conferencing
capabilities.
6',#SRUWV
The NTDK20 SSC card contains three SDI ports used to connect on-site
terminals or remote terminals through a modem. The default settings on the
ports are as follows:
7DEOH#4
6',#SRUW#GHIDXOW#VHWWLQJV
77<#3RUW
3
6HW#E\#D#',3#VZLWFK
4
5
1RWH= 7KH#EDXG#UDWH#VKRZQ#IRU#SRUWV#4#DQG#5#LV#WKH#GHIDXOW#UDWH1#3RUWV#4#DQG#5#FDQ#
EH#FRQILJXUHG#LQ#VRIWZDUH#WR#D#PD[LPXP#EDXG#UDWH#RI#4<533#ESV1
(WKHUQHW#LQWHUIDFH
The NTDK20 SSC card is equipped with a 10 Mbps Ethernet port. External
connection to the Ethernet port is provided by a 50 pin connector located in
the main cabinet. An NTDK27 Ethernet Adaptor Cable adapts this 50 pin
connector to the standard 15 pin AUI interface for a MAU.
Note: The Ethernet interface uses the same connector as the copper
expansion connector (NTAK04). Therefore, it can be used only on
systems with a Main cabinet or Main cabinet and fiber expansion
cabinets.
%DXG#UDWH
'DWD#ELWV
4533#+1RWH,
4533+1RWH,
2SWLRQ#44&
3DJH#56#RI#6:;
6WRS#ELWV
;
4
;
4
;
4
3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DULW\
1RQH
1RQH
1RQH