Nortel Meridian 1 option 11C Planning And Installation Manual page 148

3DJH#47;#RI#699
7HUPLQDO#EORFN#UHTXLUHPHQWV
886063540543 6WDQGDUG#8133
#&KDSWHU#46#±#,QVWDOOLQJ#DQG#FRQQHFWLQJ#FURVV0FRQQHFW#WHUPLQDOV#WR#FDELQHWV
The cross-connect terminal requires sufficient connecting blocks to terminate
the following:
• up to ten 25-pair cables from each cabinet.
— Each slot that is equipped with a trunk or line circuit card requires a
cable.
– The connectors J1 through J10 correspond to slot numbers 1
through 10 in the main cabinet.
– Connectors J1 through J10 correspond to slot numbers 11
through 20 in the first expansion cabinet.
– Connectors J1 through J10 correspond to slot numbers 21
through 30 in the second expansion cabinet.
– Connectors J1 through J10 correspond to slot numbers 31
through 40 in the third expansion cabinet.
– Connectors J1 through J10 correspond to slot numbers 41
through 50 in the fourth expansion cabinet.
– Allow for additional cables at the cross-connect terminal if any of
the ten slots in each cabinet are initially left vacant.
— If the NTAK19EC 2-port SDI cable or NTAK19FB 4-port SDI cable
are not used with the NTAK03 or NTAK02 cards, then a 25-pair
cable is required for each of these cards.
• nine conductors comprising the AUX cable from each cabinet.
• one 25-pair cable from each QUA6 PFTU.
• wiring from telephones and trunks.
Always use caution when installing or modifying telephone lines.
Avoid installing telephone wiring during a lightning storm. Never
touch uninsulated telephone wiring unless the line has been
disconnected at the network interface.
$SULO#5333
:$51,1*