Nortel Meridian 1 option 11C Planning And Installation Manual page 351

2EWDLQLQJ#WKH#XVH#RI#FDUG#VORW#43
If card slot 10 is required for another circuit card, simply remove the six
Meridian Mail agents programmed for this card slot. To do this, load LD 11
on the TTY and respond to the system prompts as shown below. Repeat the
procedure once for each of the six units that you want to remove.
/' 44
REQ OUT <CR>
TYPE 2008 <CR>
TN 10 XX <CR> "XX" = a value of 0,1,2,8,9, or 10
2EWDLQLQJ#WKH#XVH#RI#0HULGLDQ#0DLO#$&'#TXHXHV
The Meridian Mail feature also uses a number of ACD queues in the
Option 11 system. Refer to the section of this chapter called "Interference
with ACD queues" for information on how to remove this data from the
system.
,QWHUIHUHQFH#ZLWK#$&'#TXHXHV
The Option 11C has pre-programmed ACD queues for Meridian Mail, the
Central Answering Position, and general purpose ACD. (For some countries,
pre-programmed ACD queues are listed in "Important extension numbers" on
page 294.) To remove these values, use LD 23.
Note: Before you remove this data from the system, make sure that all
ACD agent information is removed from the queue.
In LD 23, respond to the prompts as follows:
/' 56
REQ OUT
TYPE ACD
CUST 0
ACDN XXXX "XXXX" = Value of ACD queue
Repeat for each ACD queue you wish to remove.
#&KDSWHU#56#±#&KDQJLQJ#SUH0SURJUDPPHG#GDWD
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#684#RI#699