Kdswhu#53#±#&Rqqhfwlqj#Wkh#Wuxqnv##1#1#1#1#1#1#1#1#1#1#1 - Nortel Meridian 1 option 11C Planning And Installation Manual

&KDSWHU#53#±#&RQQHFWLQJ#WKH#WUXQNV
*HQHUDO#LQIRUPDWLRQ
This Chapter describes how to connect trunks directly to the trunk card, with
or without the use of a Power Fail Transfer Unit (PFTU).
Note: The QUA6 Power Fail Transfer Unit operates with loop-start and
ground-start CO trunks. However, with ground-start trunks the
associated telephone set must be equipped with a ground-start button.
On the Option 11C, during the initial software installation, the installer has
the option of loading a default database containing pre-programmed trunk
data into software. If necessary, the default data can be modified at any time
to meet the specific needs of a customer. For a complete description of how
to modify pre-programmed trunking data, refer to "Chapter 23 – Changing
pre-programmed data" on page 345 in this Guide.
Always use caution when installing or modifying telephone lines.
Avoid installing telephone wiring during a lightning storm. Do not
install telephone jacks in wet locations unless the jack is specifically
designed for wet locations. Never touch uninsulated telephone wiring
unless the line has been disconnected at the network interface.
:$51,1*
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#58<#RI#699