Nortel Meridian 1 option 11C Planning And Installation Manual page 209

#&KDSWHU#4:#±#,QVWDOOLQJ#DQG#FRQQHFWLQJ#6',#DQG#HWKHUQHW#SRUWV
,QVWDOOLQJ#DQG#FRQQHFWLQJ#DQ#HWKHUQHW#FDEOH
)LJXUH#:9
(WKHUQHW#SRUW#ORFDWLRQ#
(WKHUQHW#FDEOH#LQWHUIDFH
(WKHUQHW#FRQQHFWLRQ
The Option 11C system provides one 10 Mbps ethernet connection to a Local
Area Network (LAN). The ethernet cable connector is located just left of the
retaining bar in the main cabinet as shown in Figure 76 on page 209.
Note: An ethernet connection is not available on systems equipped with
an NTDK26 Backwards Compatible Daughterboard on the
NTDK20 SSC card (usually multi-cabinet systems interconnected with
copper cable).
-:#-XPSHU#SOXJ
The J7 jumper plug must be in place on the NTDK20 SSC card for the
ethernet function to operate. The jumper plug is present when the NTDK20
SSC card is shipped. However, it must be removed to accommodate the
NTDK26 Backwards Compatible Daughterboard used in two-cabinet
systems that are interconnected with a copper cable.
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#53<#RI#699