Nortel Meridian 1 option 11C Planning And Installation Manual page 354

3DJH#687#RI#699 #&KDSWHU#56#±#&KDQJLQJ#SUH0SURJUDPPHG#GDWD
,QWHUIHUHQFH#ZLWK#)OH[LEOH#)HDWXUH#&RGHV
886063540543 6WDQGDUG#8133
If the pre-programmed Flexible Feature Codes interfere with the
programming required for the Option 11 system, use LD 57 to remove the
data from the system. (For some countries, default FFCs are listed in
"Flexible Feature Codes" on page 298.)
/' 8:
To change one or more access codes, type in the following commands:
REQ CHG, END
TYPE FFC
CUST 0-31
FFCT YES,(NO)
CODE aaaa
AAAA xx
CODE <CR>
REQ END
To remove one access code, type in the following commands:
REQ OUT
TYPE FFC
CUST 0-31
FFCT YES,(NO)
ALL NO
CODE aaaa
AAAA xx
CODE <CR>
REQ END
$SULO#5333
Change or end
FFC = Flexible feature codes
Customer Number
FFC Confirmation tone
Enter access code prompt (aaaa)
Enter the new access code prompt
(AAAA)
Return to REQ
End program
Action request
FFC = Flexible feature codes
Customer Number
FFC Confirmation tone
Remove specific access code
Enter access code prompt (aaaa)
Enter the new access code prompt
(AAAA)
Return to REQ
End program