Nortel Meridian 1 option 11C Planning And Installation Manual page 213

&KDSWHU#4;#±#6\VWHP#VWDUW#XS#DQG#
VRIWZDUH#LQVWDOODWLRQ
*HQHUDO#LQIRUPDWLRQ
%RRW#&RGH#FRPSDWLELOLW\
This Chapter describes how to start up the Option 11C and make sure that it
is operating properly. It also includes how to install software in a new system.
Before continuing with the procedures outlined in this Chapter, verify that all
pertinent hardware is either connected to, or installed in the system.
Make sure that the circuit breaker on the power supply in each cabinet
is set to OFF before proceeding.
If installing an NTDK81 or NTTK13 Software Daughterboard, make
sure that it is compatible with the Boot Code version on the SSC card.
It must be NTDK34AA REL 09, or higher, or NTDK34FA. Read the
information in "Chapter 12 – Installing the System Controller Card
and Components" on page 131, under the heading " SSC card, Boot
code and Software Daughterboard compatability" before proceeding.
:$51,1*
&$87,21
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#546#RI#699