Nortel Meridian 1 option 11C Planning And Installation Manual page 197

#&KDSWHU#4:#±#,QVWDOOLQJ#DQG#FRQQHFWLQJ#6',#DQG#HWKHUQHW#SRUWV
17'.56/#17'.58#DQG#17'.;3#)LEHU#5HFHLYHU#FDUGV
The Fiber Receiver cards provide one SDI port per expansion cabinet.
The baud rate is set by a DIP switch on the card's faceplate. Other
communication settings are identical to the port 0 configuration on the SSC
card (Refer to Table 25 on page 195).
A Fiber Receiver card port must be configured using overlay 17 before it can
be used to access overlays.
Note: Although all device numbers can be assigned to any cabinet, TTY
0, 1 and 2 are usually assigned to the main cabinet. TTY 3, 4, 5, and 6 are
typically assigned to the first, second, third, and fourth expansion
cabinets respectively.
Procedure 31 on page 197 describes how to connect the SDI ports on Fiber
Receiver cards.
3URFHGXUH#64
&RQQHFWLQJ#6',#SRUWV#WR#WKH#)LEHU#5HFHLYHU#FDUG
4 &RQQHFW#WKH#17$.444;#RQH0SRUW#6',#FDEOH#WR#WKH#<0SLQ#6',#
FRQQHFWLRQ#DW#WKH#ERWWRP#RI#WKH#H[SDQVLRQ#FDELQHW#ODEHOOHG#
FRQQHFWRU#³35´1#6HH#)LJXUH :8#RQ#SDJH#4<:1
)LJXUH#:8
&DEOH#FRQQHFWLRQ
17$.444;#FDEOH#FRQQHFWLRQ
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#4<:#RI#699