Nortel Meridian 1 option 11C Planning And Installation Manual page 231

&KDSWHU#4<#±#&RQQHFWLQJ#WKH#WHOHSKRQHV
*HQHUDO#LQIRUPDWLRQ
This chapter contains instructions for connecting telephones to the
cross-connect terminal. It also contains the location of the individual
extension numbers (DNs) when you are implementing one of the default
numbering plans and how to activate each telephone.
Refer to the instructions provided with the telephone or console and to
NTP 553-3001-215, Telephone Sets and Attendant Consoles Installation
Procedures, for detailed information about installing telephones and
consoles.
The cable from the cabinet card slot containing the line card associated with
the telephone being connected, must be installed before you continue. Refer
to "Chapter 13 – Installing and connecting cross-connect terminals to
cabinets" on page 147, if additional cabling is required.
&DEOH#DVVLJQPHQWV
The cables from each cabinet are labeled J1 through J10 at the cross-connect
terminal. Each cable represents a specific set of Terminal Numbers (TNs) as
shown in Table 36 on page 241.
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#564#RI#699