Nortel Meridian 1 option 11C Planning And Installation Manual page 14

3DJH#47#RI#699
#&KDSWHU#4#²#2YHUYLHZ#RI#WKH#2SWLRQ#44&
(DV\#WR#LQVWDOO#DQG#SURJUDP
886063540543 6WDQGDUG#8133
The Option 11C can be configured as a non-blocking system as it does not
need to be provisioned for speech paths or timeslots.
The system is shipped with a Software Daughterboard which is
pre-configured with system and customer data.
The Software Installation Program is automatically invoked during first-time
installation of the Option 11C system. This is a menu driven program which
installs the software and makes the Option 11C operational.
0RGHO#WHOHSKRQHV
The user has a variety of pre-programmed model telephone layouts from
which to choose. Using telephone layouts or templates, technicians can
perform a few simple steps at installation to activate multiple telephones.
$GPLQLVWUDWLRQ#WHOHSKRQH
If the default model layouts for telephones and trunk routes are used, an
administrative telephone is all that is required to make adjustments to such
things as the numbering plan and access codes. A TTY input terminal is not
required for programming the Option 11C unless a custom layout is used.
The telephones used for administrative functions can be an M2616, M2008
or M3900 digital telephone. These phonse can also double as a user's working
telephone.
&KDQJLQJ#RU#UHPRYLQJ#SUH0SURJUDPPHG#GDWD
If the pre-programmed data is not applicable to users at a particular site, the
data can be revised on-site with a TTY, or remotely over a modem
connection. If desired, the user can start with the minimal amount of data
required for initial software programming which is the configuration record.
This step must be performed while the user is in the Software Installation
Program.
$SULO#5333