Nortel Meridian 1 option 11C Planning And Installation Manual page 359

&UHDWLQJ#PRGHO#WUXQNV#DQG#FKDQJLQJ#URXWH#DFFHVV#FRGHV
&UHDWLQJ#PRGHO#WUXQNV
#&KDSWHU#56#±#&KDQJLQJ#SUH0SURJUDPPHG#GDWD
If you need a trunk that is different from the default models provided in
Option 11 software, use overlay 14 to design your own models. Route access
codes are changed using the administration telephone.
If you require additional assistance when creating your own model telephones
and trunks, refer to the Option 11C Software Input/Output guides that are
shipped with every system.
To create a new model trunk, load LD 14 and type in the following commands
on the TTY:
/' 47
REQ NEW
TYPE aaa M "aaa" = the type of trunk that you are
creating (TIE, COT, WATS, and so on).
MODL YYY "YYY" = the model number of the trunk that you are creating
(between 1 - 127)
XTRK XUT, XEM, XCOT, This prompt only appears when you
XDID define the first model in a group. Each
group consists of 16 consecutive model
definitions. (Refer to the group boundaries
listed below.) Once the first model in a
group is defined, the remaining model
numbers in the group(s) are assumed to
be of the same type.
Group boundaries are as follows:
1-15, 16-31, 32-47, 48-63, 64-79. 80-95, 96-111, 112-127.
Examples:
If, for example, you define a model trunk as XUT, with a model number of
12, all models in the group 1-15 will automatically be XUT models. If you
define another model trunk as an XEM, with a model number of 33, all
models in the group 32-47 will automatically be XEM models.
Note: When you create trunk models you are not prompted for the trunk
route or member number. This information is defined by using the
administration telephone to program the XUT or XEM circuit card.
For more information about LD 14 and its associated prompts and
commands, refer to the Option 11C Software Input/Output guides that are
shipped with the system.
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#68<#RI#699