Nortel Meridian 1 option 11C Planning And Installation Manual page 198

3DJH#4<;#RI#699 #&KDSWHU#4:#±#,QVWDOOLQJ#DQG#FRQQHFWLQJ#6',#DQG#HWKHUQHW#SRUWV
17$.35#6',2'&+#FDUG
886063540543 6WDQGDUG#8133
5 &RQQHFW#WKH#17$.444;#6',#FDEOH#WR#D#77<#WHUPLQDO1
1RWH= $#0RGHP#(OLPLQDWRU#LV#UHTXLUHG#WR#FRQQHFW#WR#D#WHUPLQDO1
6 ,I#WKH#V\VWHP#LV#WR#EH#DFFHVVHG#UHPRWHO\/#FRQQHFW#WKH#6',#FDEOH#WR#
WKH#V\VWHP#PRGHP1
7 &RQQHFW#WKH#PRGHP#WR#DQ#RXWVLGH#OLQH1
8 7HVW#WKH#PRGHP#IRU#SURSHU#RSHUDWLRQ#RQFH#\RX#KDYH#VWDUWHG#XS#
WKH#2SWLRQ#44&#V\VWHP1
—————————— End of Procedure ——————————
The NTAK02 SDI/DCH card, which can only be used in the main cabinet,
can be configured to support ports for the following:
• two SDI and two DCHI
• one SDI, one DCHI, two ESDI
• four ESDI.
NTAK02 ports can be used to access overlay software. These ports should be
defined in the configuration database as the SDI logical type.
An NTAK19FB 4-port SDI cable is designed for use with the NTAK02
circuit card. However, an NE-A25B-type 25-pair cable can be used to extend
the connections to the cross-connect terminal. See Table 26 on page 199
through Table 29 on page 202 for the connections for each port.
$SULO#5333