Removing A Horizontal-Combination-Form-Factor Expansion Card - IBM BladeCenter HS22V Installation And User Manual

10. If you have other devices to install or remove, do so now; otherwise, go to
Removing a horizontal-combination-form-factor expansion
card
Use these instructions to remove a horizontal-combination-form-factor expansion
card from the blade server.
The following illustration shows how to remove a horizontal-compact-form-factor
(CFFh) expansion card.
To remove a CFFh expansion card, complete the following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. Locate the CFFh expansion card. The CFFh is installed into the blade expansion
6. Locate the release lever on the CFFh expansion card; then, use your finger to
7. Use your fingers to hold the edge of the CFFh expansion card where it
8. Pull the card away from the expansion-card standoff.
38
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide
9. Firmly press on the indicated locations to seat the expansion card.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
"Completing the installation" on page 49.
Expansion
card
Expansion
card
standoff
page 19.
the blade server from the BladeCenter unit" on page 21 for instructions).
22 for instructions).
connector (see "Blade server connectors" on page 18).
lift up on the release lever to loosen the expansion card from the expansion
connector.
connects to the blade expansion connector; then, lift up on the card.
Release
lever
Blade
expansion
connector
cover