Planet IGS-10020HPT-U User Manual page 356

• MEG Id
This is either ITU UMC (MEG ID value[7-13]) or IEEE Short MA Name - depending on 'Format'. See
'Format'. In case of ITU ICC format this can be max. 7 char. If only 6 char. is entered the MEG ID
value[13] will become NULL.
• MEP Id
This value will become the transmitted two byte CCM MEP ID.
• cLevel
Fault Cause indicating that a CCM is received with a lower level than the configured for this MEP.
• cMEG
Fault Cause indicating that a CCM is received with a MEG ID different from configured for this MEP.
• cMEP
Fault Cause indicating that a CCM is received with a MEP ID different from all 'Peer MEP ID'
configured for this MEP.
• cAIS
Fault Cause indicating that AIS PDU is received.
• cLCK
Fault Cause indicating that LCK PDU is received.
• cSSF
Fault Cause indicating that server layer is indicating Signal Fail.
• aBLK
The consequent action of blocking service frames in this flow is active.
• aTSF
The consequent action of indicating Trail Signal Fail to-wards protection is active.
• Delete
This box is used to mark a Peer MEP for deletion in next Save operation.
• Peer MEP ID
This value will become an expected MEP ID in a received CCM - see 'cMEP'.
• Unicast Peer
This MAC will be used when unicast is selected with this peer MEP. Also this MAC is used to create
MAC HW checking of receiving CCM PDU (LOC detection) from this MEP.
• cLOC
Fault Cause indicating that no CCM has been received (in 3,5 periods) - from this peer MEP.
• cRDI
Fault Cause indicating that a CCM is received with Remote Defect Indication - from this peer MEP.
• cPeriod
Fault Cause indicating that a CCM is received with a period different what is configured for this MEP
- from this peer MEP.
• cPriority
Fault Cause indicating that a CCM is received with a priority different what is configured for this
MEP - from this peer MEP.
Buttons
: Click to add a new peer MEP.
Functional Configuration
Continuity Check:
Object Description
• Enable
Continuity Check based on transmitting/receiving CCM PDU can be enabled/disabled. The CCM
PDU is always transmitted as Multi-cast Class 1.
• Priority
The priority to be inserted as PCP bits in TAG (if any). In case of enable of Continuity Check and
Loss Measurement both implemented on SW based CCM, 'Priority' has to be the same.
• Frame rate
Selecting the frame rate of CCM PDU. This is the inverse of transmission period as described in
Y.1731. This value has the following uses:
* The transmission rate of the CCM PDU.
User's Manual of IGS-10020HPT-U
356