Table of Contents
Advertisement
Operation Support
• Remote Loopback
Support
• Link Monitoring
Support
• MIB Retrieval Support
• MTU Size
• Multiplexer State
• Parser State
• Organizational Unique
Identification
• PDU Revision
Buttons
Click to refresh the page immediately.
Auto-refresh
:
Check this box to enable an automatic refresh. Automatic refresh occurs every 3 seconds.
configuration is retrieved from the PHY.
If status is enabled, DTE is capable of OAM remote loopback mode.
If status is enabled, DTE supports interpreting Link Events.
If status ie enabled DTE supports sending Variable Response OAMPDUs.
It represents the largest OAMPDU, in octets, supported by the DTE.
This value is compared to the remotes Maximum PDU Size and the smaller of
the two is used.
When in forwarding state, the Device is forwarding non-OAMPDUs to the lower
sublayer. Incase of discarding, the device discards all the non-OAMPDU's.
When in forwarding state, Device is forwarding non-OAMPDUs to higher
sublayer.
When in loopback, Device is looping back non-OAMPDUs to the lower sublayer.
When in discarding state, Device is discarding non-OAMPDUs.
24-bit Organizationally Unique Identifier of the vendor.
It indicates the current revision of the Information TLV.
The value of this field shall start at zero and be incremented each time something
in the Information TLV changes. Upon reception of an Information TLV from a
peer, an OAM client may use this field to decide if it needs to be processed (an
Information TLV that is identical to the previous Information TLV doesn't need to
be parsed as nothing in it has changed).
238
User's Manual of IGS-10020HPT-U
Advertisement
Table of Contents
