Table of Contents
Advertisement
• VLAN ID
• Priority
• DSCP
• Auto-negotiation
• Auto-negotiation
status
• Auto-negotiation
Capabilities
Buttons
: Click to refresh the page immediately.
Auto-refresh
:
Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
not include a tag header as defined by IEEE 802.1Q-2003.
Tagged: The device is using the IEEE 802.1Q tagged frame format
VLAN ID is the VLAN identifier (VID) for the port as defined in IEEE
802.1Q-2003. A value of 1 through 4094 is used to define a valid VLAN ID. A
value of 0 (Priority Tagged) is used if the device is using priority tagged frames as
defined by IEEE 802.1Q-2003, meaning that only the IEEE 802.1D priority level
is significant and the default PVID of the ingress port is used instead.
Priority is the Layer 2 priority to be used for the specified application type. One of
eight priority levels (0 through 7)
DSCP is the DSCP value to be used to provide Diffserv node behavior for the
specified application type as defined in IETF RFC 2474. Contain one of 64 code
point values (0 through 63).
Auto-negotiation identifies if MAC/PHY auto-negotiation is supported by the link
partner.
Auto-negotiation status identifies if auto-negotiation is currently enabled at the
link partner. If Auto-negotiation is supported and Auto-negotiation status is
disabled, the 802.3 PMD operating mode will be determined the operational MAU
type field value rather than by auto-negotiation.
Auto-negotiation Capabilities shows the link partners MAC/PHY capabilities.
218
User's Manual of IGS-10020HPT-U
Advertisement
Table of Contents
