Table of Contents
Advertisement
4.3.4 Port to Group Configuration
This page allows you to configure switch Ports to use a given VLAN Translation Mapping Group. This will enable all VLAN
Translation mappings of that group (if any) on the selected switch port. The VLAN Translation screen in
appears.
The page includes the following fields:
Object
Description
• Port
The Port column shows the list of ports for which you can configure the VLAN Translation Mapping Group.
• Default
To set the switch port to use the default VLAN Translation Group click the checkbox and press Save.
• Group ID
The VLAN Translation mappings are organized into Groups, identified by the Group ID. This way a port is
configured to use a number of VLAN Translation mappings easily by simply configuring it to use a given
group. Then number of possible groups in a switch is equal to the number of ports present in this switch. A
port can be configured to use any of the groups, but only one at any given time. Multiple ports can be
configured to use the same group. A valid Group ID is an integer value from 1 to 24.
Note: By default, each port is set to use the group with Group ID equal to the port number. For example, port
#1 is by default set to use group with GID = 1.
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
Auto-refresh
: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to refresh the page immediately.
Figure 4-3-3-20: VLAN Translation Port Configuration Page Screenshot
User's Manual of IGS-10020HPT-U
157
Figure 4-3-3-20
Advertisement
Table of Contents
