Planet IGS-10020HPT-U User Manual page 200

When the IGMP address is not set, system uses IPv4 management address of the IP interface
associated with this VLAN.
When the IPv4 management address is not set, system uses the first available IPv4 management
address. Otherwise, system uses a pre-defined value. By default, this value will be 192.0.2.1.
• Mode
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR membership reports
on source ports. In Compatible mode, MVR membership reports are forbidden on source ports. The
default is Dynamic mode.
• Tagging
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged or Tagged with MVR
VID. The default is Tagged.
• Priority
Specify how the traversed IGMP/MLD control frames will be sent in prioritized manner. The default
Priority is 0.
• LLQI
Define the maximum time to wait for IGMP/MLD report memberships on a receiver port before
removing the port from multicast group membership. The value is in units of tenths of a seconds. The
range is from 0 to 31744. The default LLQI is 5 tenths or one-half second.
• Interface
When the MVR VLAN is created, select the IPMC Profile as the channel filtering condition for the
Channel specific MVR VLAN. Summary about the Interface Channel Profiling (of the MVR VLAN) will be shown
Setting by clicking the view button. Profile selected for designated interface channel is not allowed to have
overlapped permit group address.
• Port
The logical port for the settings.
• Port Role
Configure an MVR port of the designated MVR VLAN as one of the following roles.

Inactive: The designated port does not participate MVR operations.

Source: Configure uplink ports that receive and send multicast data as source ports. Subscribers
cannot be directly connected to source ports.

Receiver: Configure a port as a receiver port if it is a subscriber port and should only receive
multicast data. It does not receive data unless it becomes a member of the multicast group by
issuing IGMP/MLD messages.
Be Caution: MVR source ports are not recommended to be overlapped with management VLAN ports.
Select the port role by clicking the Role symbol to switch the setting.
I indicates Inactive; S indicates Source; R indicates Receiver
The default Role is Inactive.
• Immediate
Enable the fast leave on the port.
Leave
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
: Click to add new MVR VLAN. Specify the VID and configure the new entry. Click "Save"
User's Manual of IGS-10020HPT-U
200