Planet IGS-10020HPT-U User Manual page 292

• Other Info
This section contains information about the state of the server and the latest round-trip time.
Name
IP Address
State
Round-Trip
Time
RFC4668 Name Description
- IP address and UDP port for the authentication server
in question.
- Shows the state of the server. It takes one of the
following values:

Disabled: The selected server is disabled.

Not Ready: The server is enabled, but IP
communication is not yet up and running.

Ready: The server is enabled, IP communication
is up and running, and the RADIUS module is
ready to accept access attempts.

Dead (X seconds left): Access attempts were
made to this server, but it did not reply within the
configured timeout. The server has temporarily
been disabled, but will get re-enabled when the
dead-time expires. The number of seconds left
before this occurs is displayed in parentheses.
This state is only reachable when more than one
server is enabled.
radiusAuthClient The time interval (measured in milliseconds) between
ExtRoundTripTim the most recent Access-Reply/Access-Challenge and
e the Access-Request that matched it from the RADIUS
authentication server. The granularity of this
measurement is 100 ms. A value of 0 ms indicates
that there hasn't been round-trip communication with
the server yet.
292
User's Manual of IGS-10020HPT-U
the same server, send to a
different server, or give up. A
retry to the same server is
counted as a retransmit as well
as a timeout. A send to a
different server is counted as a
Request as well as a timeout.