Step 10: Printer: Cut Length - Ricoh MP CW2201 Field Service Manual

Hide thumbs Also See for MP CW2201:

Table of Contents

4. Replacement and Adjustment

Step 10: Printer: Cut Length

Cut Length Adjustment - Cutting Position Adjustment

This SP adjusts the distance between the DRESS sensor (image registration sensor) and

the first cut position. This setting is no longer used after the 2nd cut during continuous

printing. Cuts once to test the new setting, then once to do the actual cut.

[-10 to 10/0/0.1 mm]

• To set a length of 297 mm, with the machine cutting at 300 mm, you need to

• To set a length of 295 mm, with the machine cutting at 297 mm, you need to

• The cut length adjustment is done for all paper sizes after these settings are done.

• After these settings are done you may still need to do fine adjustments for each paper size.

1. Use the Preset Cut feature to make standard cuts of plain paper for these sizes:

2. Measure the cuts and check them against the standards of this table.

Cut Length (mm)

Less than 297

move the cutting position 3 mm upstream with a value of -3 mm.

move the cutting position downstream with a value of +2 mm

Sideways (Eng. 11")

Sideways (Eng. 17")

Lengthways (Eng. 34")

Lengthways (Eng. 44")

Cut Tolerance (mm)