Table of Contents
Advertisement
3.
If the tip of the pawl is not within the gap of the clutch arm, remove the clutch pawl plate
(
x1).
4.
Using the tip of a small screwdriver, set the clutch arm so that it is perfectly vertical..
5.
Set the clutch pawl plate so that the tip of the pawl is between the gap of the clutch arm.
6.
Attach the clutch pawl plate (
7.
If the tip of the pawl is not between the gap of the clutch arm, remove the clutch pawl
plate (
x1).
8.
Insert the alignment pin [A] into the shaft so that it is horizontal.
9.
Set the gear on the end of the shaft, and then rotate it so that the alignment mark [B] is
horizontal.
x1).
Roll Units
341
Advertisement
Table of Contents
Troubleshooting
