Scanning; Original Feed, Exit Sequence - Ricoh MP CW2201 Field Service Manual

Scanning

Original Feed, Exit Sequence

Only one original can be placed face-down on the original table.
• The original set sensor (1) detects the leading edge of the original and the original width sensors
(2) detect the width of the original.
• The original entrance roller (3) grabs the leading edge, feeds it a short distance and then stops for
1 sec. This is called Delay 1. This gives the operator time to set the paper again if it is not perfectly
straight.
• The original feed roller feeds the original to the original registration sensor (4).
• When the original registration sensor detects the leading edge of the original, the machine stops
original feed again for 1 sec. This is called Delay 2. This gives the operator another chance to
check that the original is straight.
• If the original is not straight, the user can push the original stop key (
scanner unit, remove the original, and try again.
• The length of time for Delay 1 and Delay 2 to pause can be adjusted with User Tools > System
Settings > General Features > Original Feed Delay.
• The CIS (Contact Image Sensor) (5) scans the original from below.
• The original exit sensor (6) checks the timing of the passage between the leading and trailing
edges of the original to make sure that there is no jam.
Scanner Unit
) on the right side of the
777