Dress Sensor - Ricoh MP CW2201 Field Service Manual

3. Use SP2-104-001 (Paper Edge Detection Delay Adj: Normal Paper Right Edge) and
SP2-104-002 (Paper Edge Detection Delay Adj: Normal Paper Left Edge) to adjust the left and
right margins. Here are some sample measurements and correction entries.
Margin Measured (mm)
Right
Right
Left
Left
4. Print another test pattern with SP4-417 (IPU Test Pattern Setting - Pattern Selection) Pattern 3 Grid
Pattern A and check the results.
• SP4-417
• Enter the number for the desired test pattern, switch the display to the "Copy Window" then
press the [Start] button.
5. Repeat the adjustment procedure until both measurements are equal and within range.
6. After completing the adjustment, open SP2-104-031 (Paper Edge Detection Delay Adj: Automatic
Conversion) and touch [EXECUTE].
• This saves the adjusted settings.
• These adjusted settings are applied not only to Normal Paper but all other types of paper
included under this SP code.
7. Open SP4-012 (Scanner Edge Margin).
• Touch SP4-012-007 (DF: Left Edge), and then restore the original setting noted in Step 8.
• Touch SP4-012-008 (DF: Right Edge), and then restore the original setting noted in Step 8.
• SP4-012
• These SP's define borders around the image area output by the scanner. Each edge can be
set independent of the others.

DRESS Sensor

• To remove the DRESS sensor, never loosen nor remove the two screws shown below (the figure
below shows the main unit with the carriage left cover removed).
SP
1 2104-001
4.5 2104-001
1.0 2104-002
4.5 2104-002
Carriage Unit
Enter +/- Target
+2 3
-1.5 3
-2.0 3
+1.5 3
407