Ricoh MP CW2201 Field Service Manual page 721

-70 D Batch Erase Error (Data Area Erase) Wrong Recovery of Library
-99 D Batch Erase Error (Data Area Erase) Other Errors
A data erase error of HDD/NVRAM is detected.
Recovered after performing the batch erase option (data erase of HDD/
NVRAM)
• The HDD erase program detects an error.
• An error is detected by erasing the data of NVRAM.
• The erase program (batch erase option) has not been set.
• Turn the main power OFF and back ON, and then perform batch erase
• If any HDD sector has problem, an error is generated after performing
• If the batch erase option has not been set, set it.
SC875 D Delete al error 2: Data area
An error occurred while the machine deleted data from the HDD
Note: The source of this error is the Data Overwrite Security Unit running from an
SD card.
• Cycle the machine off/on
SC876 D Log Data Error
An error was detected in the handling of the log data at power on or during
machine operation. This can be caused by switching the machine off while it is
operating.
01 D Log Data Error 1
• Damaged log data file in the HDD
• Initialize the HDD with SP5-832-004.
(HDD erase) from UP again.
batch erase again.
SC800: Firmware
CTL
CTL
715