Table of Contents
Advertisement
4. Replacement and Adjustment
5.
Remove the idle rollers by opening a support on either side.
Precaution
• To re-assemble the feed roller housing and cover plate, match the hooks [A] and bosses [B] with
their contact points, and then press the halves in the opposite direction [C].
• The holes align when the halves are locked correctly.
Roll End Sensor
1.
The roll end sensors are located on the roll unit 1 [A] and roll unit 2 [B].
To remove the roll end sensor on the roll unit 1, raise the paper exit guide.
358
Advertisement
Table of Contents
Troubleshooting
