Ricoh MP CW2201 Field Service Manual page 749

Code
58 • After the rewind button on either roll unit was pressed, the pre-registration sensor
did not detect the absence of paper within the prescribed time (after enough time
had elapsed for the paper to reverse feed from the registration standby position to
the pre-registration sensor plus 200 mm).
• During skew correction forcing a paper rewind (due to excessive skew), the pre-
registration sensor did not detect the absence of paper within the prescribed time
(after enough time had elapsed for the paper to reverse feed from the registration
standby position to the pre-registration sensor plus 200 mm).
63 During paper size detection, immediately after paper cutting, or after skew correction,
the DRESS sensor detected no paper within the prescribed time (after enough time had
elapsed for the paper to feed as far as the DRESS sensor plus 200 mm).
66 During paper edge detection, the exit sensor detected paper but the paper end sensor
signaled paper end. (The paper stopped at the exit sensor.)
84 The bypass sensor signaled no paper present during edge detection in preparation for
bypass printing.
Details
Jam Code Tables
743