Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 54

Page 54 of 376 Installing overhead cable tray kits
553-3021-210 Standard 1.00
CAUTION
System Failure
Column frames must be insulated from contact with
building structures such as concrete walls, floors,
and ceilings. Whether the cable racks are
column-mounted or ceiling-hung, the installation
must maintain the integrity of the grounding
architecture.
Procedure 4
Installing the overhead cable tray kits
1 Remove air exhaust grills at the front and rear of the top cap. Pull forward
on the two clips underneath the front edge of each grill and lift up to
remove the grill (see Figure 23).
Figure 23
Removing top cap grills
Air exhaust grill
2 Mount a support bracket at the front and rear of the module (see Figure 24
on page 55). Using two bolts, secure each support to the threaded holes
in the top of the module.
October 2003
Top cap
Air exhaust grill
Clips
Module
553-5886