Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 35

2 Vertically on the sides of the module
3 Vertically in the corner channels in the rear of the module (shielded
cables only)
CAUTION
Damage to Equipment
Cables must be routed as perpendicular as possible
to any nearby power cables. Avoid routing cables
near power cables if alternate routing is available. (At
the rear of the module, cables routed between the I/O
panel and the rear cover can be parallel to the power
cables because the panel provides EMI shielding.)
Nortel Networks recommends that you use the 90° connector end of the cable
to route the cable through a module or cabinet instead of the 180° end since
some openings are small (see Figures 12 and 13). Furthermore, Nortel
Networks recommends that you route cables top-to-bottom so gravity will
ease installation.
Figure 12
90° cable connector
Preparing for installation
Large System Installation and Configuration
Page 35 of 376
553-7497