Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 17

9 Install Power Failure Transfer Units (PFTUs) (if required); go to
"Installing Power Failure Transfer Units (PFTUs)" on
10 Configure the system monitor; go to "Configuring the system monitor"
on page 119.
11 Connect a system terminal (or modem); go to "Connecting a system
terminal or modem" on
12 Install cabling:
— To cable common equipment, go to "Cabling common equipment in
a single group system" on
— To cable network loops, go to "Cabling network modules and loops"
on page 203.
— To cable IPE Modules to the MDF and to connect lines and trunks,
go to "Cabling lines and trunks" on
13 Power up the system and load the system software; go to "Powering up
the system and initial loading" on
14 If you are upgrading your system, do not install new software, but return
to the upgrade procedures in Large System: Upgrade Procedures
(553-3021-258).
15 Perform acceptance tests; go to "Performing acceptance tests" on
page 287.
16 To test circuit cards, see "Acceptance tests" in Circuit Card: Description
and Installation (553-3001-211). To test telephones and attendant
consoles, see Telephones and Consoles: Description (553-3001-367).
17 Replace all covers and grills on the front and rear of the system.
Introduction
page 135.
page 151.
page
page 263.
Large System Installation and Configuration
Page 17 of 376
page 113.
225.