Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 42

Page 42 of 376 Placing the fourth module on a column
553-3021-210 Standard 1.00
WARNING
A fully loaded module weighs approximately 58.9 kg
(130 lbs). More than one person is required to place
a module on a column.
Procedure 2
Placing the fourth module on a column
1 Position and secure the fourth module.
a. Locate the positioning guides on the third module (see Figure 17).
b. Position the fourth module so it faces the same direction as the
column.
c. Remove the front and rear module covers on the fourth module and
rear module cover on the third module.
d. Place the fourth module on top of the column and adjust it until it is
seated securely on the positioning guides.
e. Remove the I/O safety panel in the fourth module to gain access for
installing the center mounting bolt.
f. Use a 9/16-in. socket wrench to secure the fourth module with five
mounting bolts (see Figure 18 on
October 2003
page 44).