Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 145

6 Disconnect the power cord and serial from the modem.
7 Set DIP switches 1 and 4 to ON (down) and the remaining switches OFF
(up).
Connecting a modem to an SDI port
Use Procedure 22 to connect an SDI port directly (no switch box) to a modem
(see Figure 62 on
Procedure 22
Connecting a modem to an SDI port
1 At the remote end, connect an RS-232 cable to the terminal and to the
modem.
2 At the remote end, connect the cable from the modem to an RJ11
telephone jack. If a cable is required, connect an NT8D46 cable to the
modem and to the RJ11 jack.
3 At the local end, configure the modem.
Follow the manufacturer's instructions to set the modem for 9600 baud,
auto answer, dumb mode, command recognition OFF, command echo
OFF.
4 At the local end, connect an NT8D95 cable to the SDI port on the I/O
panel in the rear of the module and to the modem.
5 At the local end, connect the cable from the modem to an RJ11 telephone
jack. If a cable is required, connect an NT8D46 cable to the modem and
to the RJ11 jack.
6 To communicate with a CPSI/COM 2 port, switch the cable from the
modem to the port as needed.
• For debugging or monitoring, connect the cable to the active CPU at
J21 on the I/O panel in the rear of the cPCI Core/Network Module.
• For patch downloading, connect the cable to the inactive CPU at J21
on the I/O panel in the rear of the cPCI Core/Network Module.
Connecting a system terminal or modem
End of Procedure
page 146).
End of Procedure
Large System
Page 145 of 376
Installation and Configuration