Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 156

Page 156 of 376
Reviewing required Core cards
Table 24
Required Core cards (minimum per Core/Net module)
Card part
number Description
NT4N65AB cCNI: cPCI Core Network Interface Card
NT4N48AA System Utility Card
NT4N64AA CP PII Call Processor Card
(256MB memory)
NT4N43CA Multimedia Disk Unit (MMDU)
Checking that the Core cards (front side) are installed
553-3021-210 Standard 1.00
Cabling common equipment in a single group system
All Core cards are installed in the factory. See Table 24 for the Core card
requirements for each Core/Net module. Refer to "System equipment –
UEMs" on page 20
All Core cards are factory installed. The four Core cards (front side) are:
1 NT4N65AB cPCI Core Network Interface (cCNI) card. Each system
contains one NT4N65 cCNI card per Core/Net module. The cCNI cards
are located in slot c9. If not already installed, install a P605337 cPCI
Card Slot Filler Panel to cover slots c10 - c12, which do not contain
cCNIs.
Note: In the NT4N41 Core/Net module, port 0 on the NT4N65 Core to
Network Interface (cCNI) Card in slot c9 must be configured as "Group
0." Communication between the bv cCNI and 3PE cards for Group 0 is
accomplished through the NT4N29 cable. Only one cCNI card is
required for Group 0.
Note: Slots c13 and c14 are left empty. If not already installed, install a
P0605337 cPCI Card Slot Filler Panel in each slot.
October 2003
for module and card descriptions.
Number
required per
Core/Net module
1
1
1
1
Backplane
side
front
front
front
front