Removing Model Telephones; Creating Model Trunks And Changing Route Access Codes - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Removing model telephones

Creating model trunks and changing route access codes

Use LD 10 to remove analog telephone models and LD 11 to remove digital
telephone models. Respond as follows to the prompts in either overlay:
LD 10 or LD 11
REQ OUT
TYPE XXXX M
CUST 0
MODL YYY
If you need a trunk that is different from the default models provided in
Small System software, use LD 14 to design your own model. Change route
access codes using the administration telephone.
If you require additional assistance when creating your own model telephones
and trunks, refer to the system software NTPs that are shipped with every
system.
Changing preprogrammed data
where "XXXX" = telephone type for the model
you are removing. (Example: 500, 2006, 2317,
2216, 3000, etc.)
where "YYY" = the model number associated
with the telephone type you are removing.
(Valid range is 1–127.)
Small System
Page 485 of 562
Installation and Configuration