Nt8D14 Universal Trunk Card - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 222 of 562

NT8D14 Universal Trunk card

553-3011-210 Standard 1.00
Installing optional circuit cards
Procedure 28
Installing the NTAK03 card
1 Insert the card in its assigned slot.
You can insert the NTAK03 TDS/DTR card into:
• any of the card slots 1 through 9 of the cabinet
• card slots 1 to 3 of the chassis
2 Connect an NTAK19 cable (or an NE-A25B cable) from the corresponding
connector at the back of the cabinet or chassis. If you are using an
NE-A25B cable, terminate this cable at the cross-connect terminal.
Because the NTAK19 cable is equipped with connectors, it does not have
to be terminated at the cross-connect terminal.
The Universal Trunk card provides eight analog trunks which can function in
the modes shown in Table 24.
You can install this line card in:
• slots 1 through 10 in the main cabinet or slots 11 through 30 in the
expansion cabinets
• slots 1 through 3 in the chassis or slots 7 through 10 in the chassis
expander
October 2003
End of Procedure