Conflicts With The Spre Code; Conflicts With The Attendant Extension Number; Changing Or Removing The Preprogrammed Night Number - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 478 of 562

Conflicts with the SPRE code

Conflicts with the attendant extension number

Changing or removing the preprogrammed night number

553-3011-210 Standard 1.00
Changing preprogrammed data
If the preprogrammed SPRE code interferes with the programming required
for the Small System, use LD 15 to remove it. (For some countries, the
default SPRE access code is listed in Table 73 on page 402.) For customer 0
enter the following in response to the SPRE prompt:
LD 15
SPRE X y
Note: To define a new SPRE code, type a space and enter the new
number.
You cannot remove the attendant extension number entirely from the
Small System data; you can only replace it with another number.
LD 15
REQ CHG
TYPE CDB
CUST x
ATDN xxxx
If you wish to change or remove the night number, use LD 15. (For some
countries, the default value of the night number is listed in
page 404.)
LD 15
REQ CHG
TYPE CDB
CUST x
NIT1 bbbb
or
October 2003
where "y" = the value of the SPRE code
where CHG = Change
where CDB = Customer Data Block
where "x" = Customer number
where "xxxx" = the new extension number
where CHG = Change
where CDB = Customer Data Block
where "x" = Customer number
where"bbbb" = the new extension number (DN)
Table 74 on