Wall Mounting In A Vertical Position - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 132 of 562

Wall mounting in a vertical position

Items required
553-3011-210 Standard 1.00
Mounting the chassis
7 If you want to add a chassis expander, follow the above steps.
You only need to leave a small space between the chassis and the
chassis expander. The air circulates from the side of the chassis. To
install the chassis expander, start in the next 5u pattern of mounting
holes. This results in the chassis expander being approximately 1/4 inch
from the first chassis.
Note: In the 5u pattern, a "u" is equal to 1.75 in. and includes three holes
spaced at 5/8 in. + 5/8 in. + 1/2 in.
Note: In addition to more chassis, you can install other Data
Communications Equipment in a rack/equipment cabinet with the
Chassis system. Refer to "Multiple pieces of equipment in an equipment
rack/cabinet" on
equipment in a rack/equipment cabinet.
To install the chassis on a wall in a vertical position, you require the following
items:
• equipment layout plan
• chassis bracket
• wall bracket
• five 1 in. #12 wood screws provided in the bracket kit (or other
appropriate fasteners) to hold the wall brackets and chassis on the wall
• four #8-32 machine screws, used to attach the chassis brackets to the wall
• one 3/4 in. (20 mm) piece of plywood fastened to the wall
October 2003
page 156 for grounding instructions for multiple pieces of
End of Procedure