Activating Terminals On A Dsl - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

You hear a short high-pitched beep lasting four seconds, followed by
silence (relocation tone).
If the extension number is already in use by another telephone, you hear
special dial tone again.
If the extension number is not available for use, you hear a fast,
high-pitched broken tone (overflow tone), and you must repeat this step.
4 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note: If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. You are prompted
for each additional extension number with three beeps followed by
continuous dial tone (special dial tone). When you are programming an
extension number, the lamp associated with that number on the
telephone is lit.

Activating terminals on a DSL

Refer to ISDN Basic Rate Interface: Installation and Configuration
(553-3001-218), for information about activating and initializing the various
terminals that can be connected to a terminal DSL.
Connecting the telephones
End of Procedure
Small System Installation and Configuration
Page 357 of 562