Key Layout - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Key layout

Attendant console features not available with a CAP
The following is a list of attendant console features that are not available with
a CAP:
• The CAP does not have the capability to provision feature keys which
function like incoming call indicators.
• The following attendant features have no equivalent on the CAP:
— Trunk Group Busy
— Incoming Call Indicators
— Attendant Administration Function Keys
— Multiple Loop Keys (for incoming/outgoing calls)
— Signal Source/Destination
The above information should be carefully considered when deciding
between the functionality of a CAP and that of an M2250 console.
A number of features make it easy for you to respond to and transfer calls
using the CAP. Each CAP telephone is preconfigured with certain features.
(Preprogrammed data can be found in "Preprogrammed data" on
To activate preconfigured CAP data, select a CAP model using the
administration telephone and carry out the appropriate overlays on the CAP,
as described later in this chapter. You are not locked into the preconfigured
model, however. If you choose, you can change features to meet your specific
needs.
The feature keys shown in Figure 136 on
most commonly used CAP functions. The CAP extension key (ACD queue)
is found at the bottom right-hand corner of the keypad and has a default
extension number.
Note: See "Using common CAP features" on
description of the common features for a CAP and for detailed
instructions on how to use each feature.
Central Answering Position
page 526
Small System Installation and Configuration
Page 525 of 562
page
provide an example of the
page 539 for a brief
399.)