Wall mounting in a horizontal position
Items required
To install the chassis on a wall in a horizontal position, you require the
following items:
•
equipment layout plan
•
one left shelf bracket
•
one right shelf bracket
•
eight 1 in. #12 wood screws supplied in the bracket kit (or other
appropriate fasteners) to fasten the wall shelf brackets to the wall
•
one 3/4 in. (20 mm) piece of plywood fastened to the wall
The NTTK11 bracket kit contains all of the above items, with the exception
of the equipment layout plan and the plywood.
DANGER
A chassis is 30 lb (13.5 kg) with circuit cards installed.
Make sure that you fasten the equipment securely to the
wall. Use fasteners designed to hold securely to the type
of surface that will support the equipment. When using
3/4 in. (20 mm) plywood, or other similar material as a
backboard, make sure you attach it directly to the wall
studs in a minimum of six places.
Refer to Figure 48 on
components.
Mounting the chassis
page 140
for guidelines on how to position system
Small System
Page 139 of 562
Installation and Configuration