Removing The Key Expansion Module(S) - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 530 of 562

Removing the key expansion module(s)

553-3011-210 Standard 1.00
Central Answering Position
8 If the telephone is equipped with a Programmable Data Adapter,
reconnect the data cable to the base telephone jack. Make sure that the
Programmable Data Adapter cable and the interface cable do not get
pinched between the base and the stand.
9 Secure the footstand to the key expansion module(s) and to the telephone
by placing the footstand tabs into the slots provided on the base of the key
expansion module and telephone and pressing down. Make sure that the
stand is firmly attached to the base. Ensure that the ribbon cable(s) are
not pinched between the footstand and the mounting posts.
10 Insert the three (or four if you have two modules) self-tapping Phillips
head screws supplied with the key expansion module into the mounting
holes in the bottom of the footstand. Tighten the screws firmly with a #1
Phillips screwdriver.
11 Tighten all screws, replace all cords and place the telephone in its normal
operating position. Place the label supplied with the key expansion
module(s) on the bottom cover of the telephone (or the footstand) for
tracking purposes.
12 Perform the self test and acceptance test procedures. (Refer to Software
Input/Output: Administration (553-3001-311) for information about these
test procedures.)
Use this procedure to remove one (single) or two (double) key expansion
modules to the M2616 or M2216 ACD CAP telephones.
Procedure 78
Removing a key expansion module
1 Remove the telephone handset and place the telephone upside down on
top of a level, solid work surface covered with soft material or paper to
avoid damaging the keys or the telephone face.
2 Disconnect all cords from the telephone.
3 Remove the screws from the stand assembly (where it meets the key
expansion module) and unsnap the stand assembly from the key
expansion module and the telephone by pressing inward at the back of
the stand (where it meets the base) and pulling upward.
October 2003
End of Procedure