Configuring Voice Gateway Media Cards On Cabinets Or Chassis - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 324 of 562
Configuring Voice Gateway Media Cards on cabinets or
chassis
553-3011-210 Standard 1.00
IP Line card configuration
Use Procedures 51 and 52 to configure the Small System's main cabinet or
chassis and any IP expansion cabinets or chassis.
Procedure 51
Configuring the ELAN IP address for the Small System active ELNK
Ethernet interface on the main cabinet or chassis, if not already defined
1 Go into LD 117.
2 Create host entries with IP address on the ELAN subnet. Enter the
following command:
NEW HOST <hostname> <IP_addr> <cab#>
Where:
<cab#> = 0, for the main cabinet or chassis
3 Configure the ELAN Mask. Enter the following command:
CHG MASK <maskvalue> <cab#>
Where:
<maskvalue> = xxx.xxx.xxx
<cab#> = 0, for the main cabinet or chassis
4 Configure a new Routing Entry. Enter the following command:
NEW ROUTE <destination IP> <gateway IP> <cab#> <port#>
Where:
<destination IP> is the ELAN IP address of IP Line card on the main
cabinet or chassis
<gateway IP> is the ELAN IP address of the main cabinet or chassis
<cab#> = 0 for main cabinet or chassis
<port#> = 0 for 10BaseT
5 Verify your IP address for the Ethernet. Enter the following command:
PRT ELNK
6 Activate New Host entry. Enter the following command:
CHG ELNK ACTIVE <hostname> <cab#>
Where:
<cab#> = 0, for the main cabinet or chassis
October 2003