Main Cabinet And Chassis Ntdk20 Ssc Card Installation - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Installing Small System Controller and Fiber Receiver cards

Main cabinet and chassis NTDK20 SSC card installation

Software daughterboard and security device installation
This section describes the steps to install a Small System Controller (SSC)
card in the main cabinet or chassis of a Small System. It also describes the
installation of the daughterboards, cables, and other components that are
required installation on the SSC card.
WARNING
The NTDK20 SSC card is equipped with components on
both sides of the circuit board. Be careful not to damage
any of the components when handling the card.
Procedure 19
Installing the software daughterboard and security device
1 Put on the antistatic wrist strap.
2 Place the SSC card on a clean flat surface.
3 Install the software daughterboard on the connector as shown in
Figure 73 on page
4 Press firmly on the standoffs to ensure that the daughterboard is secured
well to the SSC card.
5 Insert the security device labeled NT_STD in the socket with the device
markings facing outwards, as shown in Figure 73 on
192.
End of Procedure
Small System
Page 191 of 562
page 192.
Installation and Configuration