FUTABA 16SZ Instruction Manual page 98

Telemetry : RPM Sensor
The RPM Sensor screen is used to set up an
optional rpm sensor and display the rotation
information it transmits.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
will show that an alarm
will sound when the
rpm rises above the set
value.
↓ A downward arrow
will show that an alarm
will sound when the
rpm falls below the set
value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Alarm set : Over ( Under ) rotations
xxx
≧
*When the screen is tapped for one second, the rate is reset
to the initial value.
*An rpm sensor must be installed in the aircraft.
*Only receiver voltage and EXT voltage can be used in
functions.
"Magnet" SBS-01RM →
"Optics" SBS-01RO →
"Brushless motor" SBS-01RB →
If the following types are selected, the transmitter
will vibrate during the warning.
t
Type 1
Type 2
Type 3
rpm
Sets the rpm on which
the alarm operates.
Gear ratio 1.00~99.00
Blade 2~10
Pole 2~30
"Vibrator" type
＜ Linkage menu ＞
99