FUTABA 16SZ Instruction Manual page 148

Ailevator
T h i s f u n c t i o n i m p r o v e s t h e o p e r a t i n g
performance of the roll axis by operating the
elevators as ailerons.
Ailevator is where each elevator in a standard
ailerons on a wing. In addition to each elevator side
moving up and down together, each side moves in
opposite directions when moving as an ailevator.
as they can serve the same purpose. Typically,
both ailevator and ailerons are coupled together to
maximize roll performance, especially on larger
wingspan planes.
Note: Select ailevator as the Model type at the
Model type screen. This changes the output
menu and call the setup screen
shown below.
Condition group/
single mode
selection (Gr. /Sngl)
(Elevator function)
The up and down rates of the left and
right elevators when the elevator stick is
manipulated can be individually adjusted.
Tap to the item you want to adjust.
buttons.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
[Corresponding model type]: Airplane/glider, Tail type
Ailevator
(Effective only when 2 servos used at the elevators)
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
ELEVATOR
(AILERON 5)
(Aileron function)
When the elevators are used as
ailerons, aileron travel of the left and
right elevators can be adjusted.
ELEVATOR 2
(AILERON 6)
149