FUTABA 16SZ Instruction Manual page 38

S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T16SZ. Channel setting and
other data can be entered for the S.BUS/S.BUS2 servos or sensors.
2. Turn on the transmitter power.
3. Call the setup screen.
Servo: System Menu
Sensor: Linkage Menu
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
WARNING
Do not disconnect or turn transmitter power OFF
while S.BUS servo and telemetry sensor data is
being saved.
■ S.BUS servo and sensor save data will be lost,
resulting in malfunction.
＜ Before Use ＞
Sensor
39