FUTABA 16SZ Instruction Manual page 123

The angle and curve of each operation function can be set. [All model types]
AFR
AFR function is used to adjust the throw and
operation curve of the stick, lever, and switch
When D/R is turned ON, the display will
show "D/R----", and the rudder angle (rate)
and EXP can be set when D/R is ON.
1. When the function select button is tapped, a selection screen appears.
2. Select the function you want to set at the selection screen.
124 ＜ Model menu (Common Functions) ＞
Rate
100%
Rate
40%
the setup screen shown below.
● Operation curve setting
(For a description of the setting method, see the
description at the back of this manual.)
the maximum throw. When mixing is applied from
one channel to another channel, both channels
can be adjusted at the same time by adjusting the
operation rate through the AFR function.
of curves (EXP1, EXP2, and Point) can be
used for the point curve type. (Initial setting:
9 points) The number of points can also be
increased and decreased and curves from
complex curves to simple curves can be
used.
speed of each function when the function
is operated (including at flight condition
operates smoothly at a constant speed
corresponding to the set speed.
● Group/single mode switch (Gr./Sngl)
(For more information, see the
description at the back of this manual.)
● Servo speed setting
(For a description of the setting
method, see the description at
the back of this manual.)
Curve select
EXP1, EXP2, Point curve
Curve select
Separately ⇔ Combination
(Left and right
symmetrical
curve.)
Left/right, Up/down, overall
adjustment at Rate A and
Rate B