Table of Contents
Advertisement
•Stick Tension (J1)
(Mode 1/2)
•Stick Tension (J2)
(Mode 2)
The T16SZ transmitter model data can be stored by using any commonly found SD card. When
capable of using SD and SDHC cards (SD:32MB-2GB SDHC:4GB-32GB).
Saving model data and update files (released
from Futaba) into the SD card, you can use those
electronics stores.
•Stick Tension (J4)
(Mode 1/2)
•Stick Tension (J3)
(Mode 1)
4. Use a screw driver to adjust the spring
s t r e n g t h a s y o u p r e f e r b y t u r n i n g t h e
adjusting screw of the stick you want to
adjust.
CAUTION: Loosening the screw too much
can interfere with the internal stick operation.
Turn screw counter-clockwise.
Stick tension minimum
5. At the end of adjustment, re-install the side
cover and rear grips.
When you have a problem of saving or reading
card.
*We are not responsible for, and offer no compensation for,
memory card data that fails or is damaged for any reason.
Be sure to keep a backup of all important data stored in your
SD card.
＜ Before Use ＞
Turn screw clockwise.
Stick tension maximum
29
Advertisement
Table of Contents
