Timer
The Timer function may be set for
any desired time, i.e. engine run time,
specified times for competitions, etc.
Two independent timers are provided
for your use. The timers are stored
independently with each model, meaning
that when you switch between model
setups, the timer associated with the new
model is brought up automatically.
The timers may be set to start and stop
from the motion of any switch or stick.
freely. Each timer has a capacity of up to
[Inhibit] → [Type1-4]
If it carries out like this,
a vibration function
will work.
Up timer/Down timer selection
Each timer may be set for count-down or count up
operation with a target time.
If a target time is set and the timer reaches the set time, a
buzzer sound for each count is generated.
Time :
OFF: Turning the power OFF and switching models will reset the timer.
ON: Previous timer is put into memory and will restart from where it stopped.
[Start/Stop] → Home screen
A timer on the home screen starts and stops its countdown
directly from there when tapped. Tapping and holding the
display will reset the timer.
Timer 1
Last twenty seconds
Last ten seconds
One short
Alarm :
beep
Timer 2
Start/Stop/Reset switch setting
< Linkage menu >
Target time
Two short
Continue counting
Also
beeps
with displaying a
minus (-) sign.
beep
Elapsed: Minute-by-minute
alarm starting from 00:00
Remainder : Minute-by-
minute alarm counting down
from a designated time
A Buzzer or Speech
can be chosen
87