FUTABA 16SZ Instruction Manual page 137

Airbrake → ELE
This mix is used when you want to mix the
elevators with airbrake (spoiler) operation. It
raises the elevators to correct for dropping of the
nose during airbrake operation.
*This function does not operate when airbrake is not assigned
at the Function menu in the Linkage menu.
elevator servos can be adjusted.
menu and call the setup screen shown
below.
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Setting method
the switch and tap the screen to call the
selection screen, and then select the switch
this manual.
138 ＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]:
Airplane/glider, general
ELEVATOR
*The display screen is an example. The actual
screen depends on the model type.
Currently selected condition name
mode can also be set.
AIR BRAKE
AILVATOR
V-TAIL
ELEVATOR
ELEVATOR 2
Up/Down overall
adjustment at Rate A
and Rate B
Adjustment of
elevator servo
Fine tuning
setting
ELEVATOR 2